Skip to content Skip to navigation menu
975.30 Jowat® CyanoacrylaatID97530
Universeller Cyanacrylat Sekundenklebstoff von Jowat® für zahlreiche Materialien, sehr gut fließend, haftstark, trocknet schnell mit hoher Endfestigkeit.

excl. btw, plus verzendkosten

Application:

For bonding materials used in the electrical, electronics and toy as well as in the rubber industries, also for precision mechanics and the optical industry. Not suitable for glass.

Characteristics / Directions for Use:

This product sets very fast and will lead to excellent unstressed and vibration-resistant bonds. Surfaces have to be free of dirt, grease or oil. The parts to be bonded have to match perfectly. For gaps up to 0.5 mm, the limit here needs to be established by prior testing. One-sided application is sufficient, afterwards join the parts to be bonded immediately. The adhesive reacts with humidity and this causes setting. If the rel. humidity is <40 %, curing may be difficult. When the humidity is normal, the setting takes place within a few seconds, max. a few minutes (depending on material properties and ambient conditions). Our Application Technology Department and our Application Specialists will provide technical data to assist you in your choice of an appropriate product for your requirements. Please observe the information in the section “Remarks”.

Cleaning:

While still liquid, the material may be removed by using acetone. After curing, it can only be removed mechanically (e.g. emery paper).

Storage:

The product should remain stored in properly closed original containers, dry and cool (2 – 8 °C), but not below 0 °C. For best-before date, please see container label.

Packaging:

Information about packaging types and units is available upon request.

Remarks:

For further information concerning safety, handling, transport and disposal, please refer to the Safety Data Sheet. The information on this data sheet is based on test results from our laboratories as well as on reported experience gained in the field by our customers. It can, however, not cover all parameters for each specific application and is therefore not binding upon Jowat, nor should it be relied upon in lieu of your own required testing. The information given in this leaflet does not represent a performance guarantee. Unless otherwise agreed with our customers, the values stated in the section “Specification” shall be regarded as the finally agreed upon product properties. No liability may be derived from the information contained herein nor from the information provided by our free technical advisory service.

Please refer to the "Download" tab for the safety data sheet.

Base Cyanacrylat (CA)
Viscosity bei 25 °C ca. 1.100 ± 200 mPas (Brookfield, Spindel 2, 12 UPM)
VOC content (Swiss) 0,00%