Application:

For cleaning applicator units and tools which have been soiled with crosslinked PUR hot melt adhesives.

Characteristics / Directions for Use:

Melt and applicator units may be cleaned by continuous circulation of the cleaner which has been heated to 180 – 190 °C. The cleaning of disassembled tools, nozzles and seals of PTFE (Teflon, Hostaflon etc.) can be carried out in a bath of Jowat® 930.60 also heated up to 180 – 190 °C. Depending on the amount of reacted/crosslinked adhesive, cleaning may take approx. 60 min. The cleaner Jowat® 930.60 should not be allowed to reach temperatures above 190 °C. Tools and disassembled parts are cooled under running water after removal from the bath, then dried. Caution: May catch fire. Moisten the cleaning cloth prior to use and rinse with water after cleaning. Our Application Technology Department and our Application Specialists will provide technical data to assist you in your choice of an appropriate product for your requirements. Please observe the information in the section “Remarks.” Customer trials are required.

Storage:

The product should remain stored in properly closed original containers, dry and cool (15 – 25 °C). For best-before date, please see container label. After the elapse of the best-before date, it is essential that you again verify that the product is fit for your intended application.

Packaging:

Information about packaging types and units is available upon request.

Remarks:

For further information concerning safety, handling, transport and disposal, please refer to the safety data sheet. The information on this data sheet is based on test results from our laboratories as well as on reported experience gained in the field by our customers. It can, however, not cover all parameters for each specific application and is therefore not binding upon Jowat, nor should it be relied upon in lieu of your own required testing. The information given in this leaflet does not represent a performance guarantee. Unless otherwise agreed with our customers, the values stated in the section “Specification” shall be regarded as the finally agreed upon product properties. No liability may be derived from the information contained herein nor from the information provided by our free technical advisory service.

Please refer to the "Download" tab for the safety data sheet.