text.skipToContent text.skipToNavigation
403.30 Jowat® SpoelmiddelID40330

Prix sans Livraison, hors taxe TVA et COV si applicable.


Flushing and soaking agent for one-component PUR prepolymer application units.

Characteristics / Directions for Use:

May cause swelling in non-resistant sealing material. All seals should be made of resistant materials like for instance Viton® (flouroelastomer), Teflon® (poyltetrafluoroethylene) or Cantellen® (rubber-bonded synthetic fibres). Very good gelling power when used with various polymers like for instance PUR. Clean units with Jowat® Cleaner 401.30 or Jowat® PUR Cleaner. Do not allow the cleaned units to stand empty, but flush with flushing and soaking agent Jowat® 403.30 and keep filled. Customer trials are required. Our Application Technology Department and our Application Specialists will provide technical data to assist you in your choice of an appropriate product for your requirements. Please observe the information in the section “Remarks.”


The product should remain stored in properly closed original containers, dry and cool (15 – 25 °C). For best-before date, please see container label. After the elapse of the best-before date, it is essential that you again verify that the product is fit for your intended application.


Information about packaging types and units is available upon request.


For further information concerning safety, handling, transport and disposal, please refer to the safety data sheet. The information on this data sheet is based on test results from our laboratories as well as on reported experience gained in the field by our customers. It can, however, not cover all parameters for each specific application and is therefore not binding upon Jowat, nor should it be relied upon in lieu of your own required testing. The information given in this leaflet does not represent a performance guarantee. Unless otherwise agreed with our customers, the values stated in the section “Specification” shall be regarded as the finally agreed upon product properties. No liability may be derived from the information contained herein nor from the information provided by our free technical advisory service.

Please refer to the "Download" tab for the safety data sheet.

Base agent de mouillage
Viscosity 125 ± 15
Density at +20 °C [g/cm³] 0.84 ± 0.01
Appearance of the glue film slightly yellowish, clear liquid
VOC content (Swiss) 0,00%