Cleaner for flammable polychloroprene and foam upholstery adhesives. Special cleaner for hot melt adhesives.
Characteristics / Directions for Use:
Avoid contact of this product with all electrical connections or hot items. Remove the hot melt adhesive first by heating and scraping off with a spatula. Soak the tools/equipment after cooling down in Jowat® 401.10 for 10 –12 hours, then clean. Customer trials are required. Our Application Technology Department and our Application Specialists will provide technical data to assist you in your choice of an appropriate product for your requirements. Please observe the information in the section “Remarks.”
The product should remain stored in closed original containers, dry and cool. For best-before date, please see container label. After the elapse of the best-before date, it is essential that you again verify that the product is fit for your intended application.
Information about packaging types and units is available upon request.
For further information concerning safety, handling, transport and disposal, please refer to the safety data sheet. The information on this data sheet is based on test results from our laboratories as well as on reported experience gained in the field by our customers. It can, however, not cover all parameters for each specific application and is therefore not binding upon Jowat, nor should it be relied upon in lieu of your own required testing. The information given in this leaflet does not represent a performance guarantee. Unless otherwise agreed with our customers, the values stated in the section “Specification” shall be regarded as the finally agreed upon product properties. No liability may be derived from the information contained herein nor from the information provided by our free technical advisory service.
For the complete technical data sheet click here
Please refer to the "Download" tab for the safety data sheet.
|Density at +20 °C [g/cm³]||at 20 °C [g/cm³] : 0.755 ± 0.015|
|VOC content (Swiss)||100,00%|