text.skipToContent text.skipToNavigation
233.10 Jowat-Toptherm® PO-HotmeltID23310
Optimierter PO Schmelzklebstoff von Jowat® für Montageanwendungen mit speziellen Klebeeigenschaften zur Herstellung von Betonfertigteilen.

Prix sans Livraison, hors taxe TVA et COV si applicable.


Assembly operations.

Characteristics / Directions for Use:

Good heat resistance , very good resistance to oxidation and colour stability in the melt. Our Application Technology Department and our Application Specialists will provide technical data to assist you in your choice of an appropriate product for your requirements. Please observe the information in the section “Remarks”. General bonding requirements The properties (e.g. surface tension, plasticiser content…) and the conditioning of the substrates, as well as the processing conditions (e.g. ambient temperature, humidity…) will influence the processes of joining and bonding. Customer tests under consideration of everyday production conditions are therefore absolutely necessary to define stable process parameters and to ensure that the product is fit for purpose. For best bonding results, the materials to be bonded should be free of dust, oil, and grease, and be dry. Wood moisture content should be at 8 – 10 %. Ideally, the minimum temperature should be at 18 °C. Avoid draught.


Preliminary mechanical cleaning while hot (e.g. with a spatula). Remove any residues in the application environment when cold with Jowat® Cleaner 402.40. Safety instructions: Safety instructions: The German Adhesives Association developed the following recommendation concerning the processing of hot melt adhesives which are not subject to classification: “When hot melt adhesives are melted, vapours may be set free. The composition and amount of the vapour depends on the type of adhesive, the application method, and the processing temperature. The instructions of the manufacturer, especially with regard to the processing temperature, must be strictly adhered to. Vapours are to be extracted with suitable extraction and ventilation systems.” The Technical Leaflet “Voluntary warning information for hot melt adhesives not subject to classification” can be made available upon request.


The product should remain stored in closed original containers, dry and cool. For best-before date, please see container label. After the elapse of the best-before date, it is essential that you again verify that the product is fit for your intended application.


Information about packaging types and units is available upon request.


For further information concerning safety, handling, transport and disposal, please refer to the Safety Data Sheet. The information on this data sheet is based on test results from our laboratories as well as on reported experience gained in the field by our customers. It can, however, not cover all parameters for each specific application and is therefore not binding upon Jowat, nor should it be relied upon in lieu of your own required testing. The information given in this leaflet does not represent a performance guarantee. Unless otherwise agreed with our customers, the values stated in the section “Specification” shall be regarded as the finally agreed upon product properties. No liability may be derived from the information contained herein nor from the information provided by our free technical advisory service.

For the complete technical data sheet click here

Please refer to the "Download" tab for the safety data sheet.

Base Polyolefin (PO)
Viscosity at 200 °C: 1.500 ± 500 mPas
Processing temperature 180 – 200 °C
Density at +20 °C [g/cm³] at 20 °C approx. 0,90 ± 0,03 g/cm³
Open waiting time bead 1,5 ± 0,5 Minuten
Softening range 80 ± 5 °C