Skip to content Skip to navigation menu
931.00 Jowat® Cleaning/Flushing agentID93100
Hochviskoses hinterwanderndes Spülmittel von Jowat® zur Reinigung von EVA- und PO-Schmelzklebstoffen in Auftragssystemen.

excl. VAT plus Shipping

Application:

For flushing out applicator units for PO or EVA hot melt adhesives. Not to be used for flushing out applicator units for PUR hot melt adhesives.

Characteristics / Directions for Use:

Allow all adhesive to be extruded completely. Then fill the unit with the Jowat® flushing agent 931.00 and melt. The entire amount of flushing agent has to run through the hose and nozzle , then repeat the procedure to ensure that all hot melt residues have been removed. Before taking up work again, the flushing agent has to be completely removed from the equipment. Our Application Technology Department and our Application Specialists will provide technical data to assist you in your choice of an appropriate product for your requirements. Please observe the information in the section “Remarks.”

Storage:

The product should remain stored in properly closed original containers, dry and cool (15 – 25 °C). For best-before date, please see container label. After the elapse of the best-before date, it is essential that you again verify that the product is fit for your intended application.

Packaging:

Information about packaging types and units is available upon request.

Please refer to the "Download" tab for the safety data sheet.

Base Spülmittel
Viscosity bei 190 °C: 52.500 ± 12.500 mPas (Brookfield, Thermosel, Spindel 28, 5 UPM)
Density at +20 °C [g/cm³] ca. 0,90 ± 0,02 bei 23 °C g/cm³ (Jowat Prüfmethode)
VOC content (Swiss) 0,00%
Softening range 100 ± 5 °C (Kofler Heizbank)